Basler Ext. Cable for Cable or Power Supply With HRS 6p, m/f, P#
The cable is suitable for the following camera models:
- ace USB 3.0
- ace GigE
- aviator CL
- racer GigE
- racer CL
|Order Number||Cable Length|
CAUTION – Electric Shock and Fire Hazard
To avoid electrical shock or fire hazards only SELV (Safety Extra Low Voltage) and LPS (Limited Power Source) may be used.
The maximum current allowed is 2 A.
Using the power-I/O cable extension may cause problems in camera operation.
Using the cable extension increases the length of the standard power-I/O cable designed for Basler cameras to up to 18 m. Compared to the standard power-I/O cable, the voltage drop between the power supply and the camera will be higher. Therefore, you need to consider the following aspects:
- This increases the risk of supplying power with insufficient voltage for proper camera operation.
- The signal latency will increase.
- The likelihood for picking up extraneous signals increases. Therefore, problems with electromagnetic interference (EMI) and electrostatic discharge (ESD) may increase.
To ensure proper camera operation, make sure that power with sufficient voltage is supplied by the power supply. The voltage available at the camera must at least match the strength specified in the respective camera user's manual.
|Pin Number||Wire Color||Function|
|1||Brown||See camera documentation|
|2||Green||See camera documentation|
|3||Pink||See camera documentation|
|4||Gray||See camera documentation|
|5||Yellow||See camera documentation|
|6||White||See camera documentation|
For more details, see the respective camera user documentation.
|Camera-side Connector||Hirose 6 pin [HR10A-7P-6S (73)]|
|Host-side Connector||Hirose 6 pin [HR10A-7J-6P (73)]|
|Cable Cross-section||3 x 2 x 0.14 mm² (close to AWG 21)|
|Cable Diameter||5.3 mm|
|Minimum Bending Radius||Fixed installation: 31.8 mm (6 x cable diameter) |
Moved occasionally: 79.5 mm (15 x cable diameter)
|Maximum Bending Cycles||None (fixed installation only)|
|Suitable for Drag Chain Applications||No|
|Suitable for Robotics Applications||No|
|Maximum Operating Voltage||See camera documentation for the power requirements of your camera.|
|Wire Resistance||148 Ω/km|
|Operating Temperature Range||-25–80 °C, not moving|
|Durability||>1000 mating cycles|
|Contact Resistance||10 mΩ min.|
|Plug Insulation Material||Polyamide/PBT|
|Conformity||CE (includes RoHS) |
Certificates for your cable
For more information, see the Compliance section of the Basler website.
Read the topic about your camera model before connecting the cable to the camera. You can find your camera topic in the Area Scan Cameras section under "Models".
For cameras not included in the Basler Product Documentation, see the Document Downloads section of the Basler website.