Skip to content

Basler Power-I/O Cable HRS 6p/open, S#

Power-I/O cable with HRS 6-pin connector and open end.

Basler Power-I/O Cable HRS 6p/open, S

Info

The cable is suitable for the following camera models:

  • ace GigE (cable not recommended for use with GPIO)
  • aviator CL (power only)
Order Number Cable Length
2200000625 5 m
2200000626 10 m

Cable Drawing#

Cable Drawing

CAUTION – Personal Injury Hazard

Personal injury hazard and risk of damage to camera in case of short circuits (applies to GigE cameras only)

Short circuits may cause an extreme rise in temperature of the camera's housing. This may damage the camera and may also lead to personal injuries, e.g., burns if touching the housing. In the worst case, the overheating may cause a fire. In order to prevent that, you should take additional measures to limit the current flowing through each individual wire during a short circuit. The maximum current allowed is 2 A. There are two ways how to do this:

  • Using a fuse
  • Using a limited power supply

Wiring Information#

Pin Number Wire Color ace GigE
without GPIO
ace GigE
with GPIO
aviator CL
1 Brown Camera Power Camera Power Camera Power
2 Pink Opto-isolated IN (Line1) Opto-isolated IN (Line1) Camera Power
3 Green Not connected GPIO (Line 3) Not connected
4 Yellow Opto-isolated OUT (Out1) Opto-isolated OUT Not connected
5 Gray Opto-isolated I/O Ground Opto-isolated I/O Ground Camera Power Ground
6 White Camera Power Ground Camera Power and GPIO Ground Camera Power Ground

For more details, see the respective camera documentation.

Physical Specifications#

Camera-side Connector Hirose 6 pin [HR10A-7P-6S (73)]
Host-side Connector None, open end
Cable Cross-section 3 x 2 x 0.14 mm² (close to AWG 26)
Cable Diameter 5.8 mm
Wire Insulation PVC
Outer Jacket PVC
Minimum Bending Radius 34.8 mm (6 x cable diameter), fixed installation
Maximum Bending Cycles None (fixed installation only)
Suitable for Drag Chain Applications No
Suitable for Robotics Applications No

Electrical Specifications#

Maximum Operating Voltage See camera documentation for the power requirements of your camera.
Test Voltage 1200 VDC
Wire Resistance ≤142 Ω/km

Environmental Specifications#

Operating Temperature Range -25–80 °C, not moving

Plug Specifications#

Durability >1000 mating cycles
Contact Resistance 10 mΩ max.
Contact Plating Gold
Protection Rating IP40
Plug Insulation Material Polyamide/PBT

General Information#

Conformity CE (includes RoHS)
Certificates for your cable
For more information, see the Compliance section of the Basler website.
Warranty 1 year

Read the topic about your camera model before connecting the cable to the camera. You can find your camera topic in the Area and Line Scan Cameras section under "Models".

For cameras not included in the Basler Product Documentation, see the the Document Downloads section of the Basler website.