Skip to content

Basler GP-I/O Cable, HRS 6p/open, P#

Input/Output (I/O) cable for connecting to the direct-coupled GPIO pins (GPIO, GPIO Ground) of the 6-pin connector of ace USB 3.0 camera models. For ace GigE camera models (with GPIO) the cable connects to the direct-coupled GPIO pin (GPIO, GPIO Ground) and the camera power pin of the 6-pin connector.

Basler GP-I/O Cable 6p/Open, P

Info

The cable is suitable for the following camera models:

  • ace USB 3.0
  • ace GigE (only models with GPIO)
Order Number Cable Length
2000034087 10 m

Cable Drawing#

Cable Drawing

CAUTION – Personal Injury Hazard

Personal injury hazard and risk of damage to camera in case of short circuits (applies to GigE cameras only)

Short circuits may cause an extreme rise in temperature of the camera's housing. This may damage the camera and may also lead to personal injuries, e.g., burns if touching the housing. In the worst case, the overheating may cause a fire. In order to prevent that, you should take additional measures to limit the current flowing through each individual wire during a short circuit. The maximum current allowed is 2 A. There are two ways how to do this:

  • Using a fuse
  • Using a limited power supply

Wiring Information#

Pin Number Wire Color USB 3.0 Cameras GigE Cameras with GPIO
1 Brown GPIO (Line 3) Camera Power
2 n/a Not connected Not connected
3 Yellow GPIO (Line 4) GPIO (Line 3)
4 n/a Not connected Not connected
5 n/a Not connected Not connected
6 White/Green GPIO Ground Camera Power Ground / GPIO Ground

Info

To achieve the best possible signal-to-noise ratio, both GPIO ground wires have to be connected to ground. Additionally, if you're not using one of the GPIO lines, connect the wire of that GPIO line to ground as well.

Physical Specifications#

Camera-side Connector Hirose 6 pin [HR10A-7P-6S (73)]
Host-side Connector None, open end
Cable Cross-section 2 × 2 × 0.14 mm² (close to AWG 26)
Cable Diameter 4.9 mm max.
Wire Insulation PVC
Outer Jacket PVC
Color Outer Jacket Yellow
Minimum Bending Radius 34.3 mm (7 x cable diameter)
Maximum Bending Cycles None (fixed installation only)
Suitable for Drag Chain Applications No
Suitable for Robotics Applications No

Electrical Specifications#

Maximum Operating Voltage See camera documentation for the power requirements of your camera.
Wire Resistance ≤142 Ω/km

Environmental Specifications#

Operating Temperature Range -25–80 °C

Plug Specifications#

Durability >1000 mating cycles
Contact Resistance 10 mΩ max.
Contact Plating Silver
Protection Rating IP40
Plug Insulation Material Polyamide/PBT

General Information#

Conformity CE (includes RoHS)
Certificates for your cable
For more information, see the Compliance section of the Basler website.
Warranty 3 years

Read the topic about your camera model before connecting the cable to the camera. You can find your camera topic in the Area and Line Scan Cameras section under "Models".